Andover Audio SpinDeck Max Automatic Turntable Support Articles.
The SpinDeck MAX uses a one-piece flat belt that drives a sub-platter under the aluminum outer platter. The belt is installed at the factory. It is very similar to the setup used our Model-One Turntable System. Speed switching is electronic and does
Note that there may be some tension putting the dust cover into the hinge. This is expected. We recommend putting the hinge on the dust cover first, then slipping the hinge into the base. This will allow some more control over sliding the hinge onto
The Auto Start lowers the arm right at the beginning of the record. It automatically returns the arm when it reaches the end of the record.
Lift the chassis out of the plinth by removing the two screws that the red shipping clips were slid under. Then carefully lift the chassis out of the plinth and you will see the adjustment screws under the motor. There is one for 33 and one for 45. Y
We do not currently sell replacement needles or cartridges. The SpinDeck Max comes with a Ortofon OM10 cartridge. These easily slide on and off. This video should be helpful with replacing your stylus, and to see how it works. They pull right off..