Model-One Turntable System
Andover Audio Model-One Turntable System Support Articles
Model-One Subwoofer Setup
For the Subwoofer connection, there are 2 cables. Both are the same, different length. Connect Sub (RCA out) on the back of the Model-one to the RCA input on the Subwoofer with one of the cables. To make sure you are getting the best Bass response f
Model-One and 78 Records
The Model-One manual has some info on playing 78 records. In the manual Page 8:. STEP 2 - Install the Drive Belt. Install the flat drive belt by stretching it around the inner platter and over the “top step” of the small motor pully to use with 33 or
Model-One Outputs
The Model-One has PRE-OUT (Preamp output): Which outputs an unamplified signal to an external amplifier, or a set of powered speakers. There is also a SUB-Out (Preamp output): A monaural Preamp output for use with a subwoofer. The manual is availabl
Model-One Cartridge Needle and Stylus
We do not currently sell replacement needles or cartridges. The Model-One uses an Ortofon 2M "Silver". These easily slide on and off.
Model-One stops spinning
The platter will stop spinning on the Model-One if the source is switched to another source such as Bluetooth or Aux, or when the power is turned off.
Model-One Sound Quality and Basssettings
To make sure you are getting the best Bass response from your Model-One, check this setting. This setting redirects some Bass frequencies to the Subwoofer output.
Model-One Digital Inputs Hi-Res
The Optical input will accept up to 24/96 and the Coaxial will accept up to 24/192. So either of those are the primary digital inputs for high resolution. The USB is limited to 16/48 and is there primarily for ripping to a computer. A simple converte
Model-One Reset Factory Settings
Unplug the power supply from the wall and wait 30 seconds. Then Plug it back in. Also, you can navigate to Preferences > Info > Factory Reset.
Model-One Remote Battery
The Remote uses a CR2025 battery. If the battery it placed upside down, it will not work.